This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
howto:dumlcapture [2021/11/02 03:18] czokie |
howto:dumlcapture [2021/11/02 03:29] czokie |
||
---|---|---|---|
Line 48: | Line 48: | ||
cd /tmp | cd /tmp | ||
rm -rf mefisto | rm -rf mefisto | ||
+ | |||
+ | ==== 3. Restart Wireshark and capture ==== | ||
+ | Start a packet capture in Wireshark, from the XHC20 interface. | ||
+ | ==== 4. Set a display filter ==== | ||
+ | |||
+ | (frame.protocols == " | ||
+ | |||
+ | This filter is designed to capture all valid dji_dumlv1 packets, but also to capture any poorly decoded packets to allow you to look at the cause of any problems with the dissectors. | ||
+ | |||
+ | ==== 5. Set display columns ==== | ||
+ | |||
+ | This is an optional step, but it will make it easier to read and interpret a DUML flow at a glance. | ||
+ | |||
+ | * Click Wireshark >> Preferences >> Appearance >> Columns | ||
+ | * Configure to your requirements. A sample layout is shown below. | ||
+ | {{: | ||