howto:dumlcapture
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
howto:dumlcapture [2021/11/02 03:20] czokie |
howto:dumlcapture [2021/11/02 03:29] czokie |
||
|---|---|---|---|
| Line 56: | Line 56: | ||
| This filter is designed to capture all valid dji_dumlv1 packets, but also to capture any poorly decoded packets to allow you to look at the cause of any problems with the dissectors. | This filter is designed to capture all valid dji_dumlv1 packets, but also to capture any poorly decoded packets to allow you to look at the cause of any problems with the dissectors. | ||
| + | |||
| + | ==== 5. Set display columns ==== | ||
| + | |||
| + | This is an optional step, but it will make it easier to read and interpret a DUML flow at a glance. | ||
| + | |||
| + | * Click Wireshark >> Preferences >> Appearance >> Columns | ||
| + | * Configure to your requirements. A sample layout is shown below. | ||
| + | {{: | ||
| + | |||
howto/dumlcapture.txt ยท Last modified: 2021/12/04 20:57 by lawq
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
