howto:modp3params
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
howto:modp3params [2019/07/21 23:26] digdat0 updated install steps for inspire |
howto:modp3params [2019/07/21 23:29] digdat0 [Important Parameter Descriptions] |
||
|---|---|---|---|
| Line 133: | Line 133: | ||
| ^ voltage2.user_set_smart_bat_0|Battery type (DJI vs non-DJI)| | ^ voltage2.user_set_smart_bat_0|Battery type (DJI vs non-DJI)| | ||
| ^ voltage2.level2_smart_battert_land_0|SmartRTH battery landing %| | ^ voltage2.level2_smart_battert_land_0|SmartRTH battery landing %| | ||
| + | ^ advanced_function.driver_license_limit_enable_0|DJI Driver License Pilot| | ||
| + | ^ advanced_function.viechle_license_limit_enable_0|DJI Driver License Aircraft| | ||
| ====== Parameter Values to Change ====== | ====== Parameter Values to Change ====== | ||
| I removed the g_config from the prefix to make the table fit better :) | I removed the g_config from the prefix to make the table fit better :) | ||
howto/modp3params.txt ยท Last modified: 2019/07/21 23:35 by digdat0
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
