Differences

This shows you the differences between two versions of the page.

--- howto:modp3params [2019/07/21 23:26]
digdat0 updated install steps for inspire
+++ howto:modp3params [2019/07/21 23:32]
digdat0 drivers license parms
@@ Line 133: / Line 133: @@
 ^ voltage2.user_set_smart_bat_0|Battery type (DJI vs non-DJI)|
 ^ voltage2.level2_smart_battert_land_0|SmartRTH battery landing %|
+^ advanced_function.driver_license_limit_enable_0|DJI Driver License Pilot|
+^ advanced_function.viechle_license_limit_enable_0|DJI Driver License Aircraft|
 ====== Parameter Values to Change ======
 I removed the g_config from the prefix to make the table fit better :)
-Last edit: digdat0 11/06/2018. use the tilt and vert up/down as guidelines.
+Last edit: digdat0 07/21/201. adding license param. use the tilt and vert up/down as guidelines.
 **Height Limit Removal**
@@ Line 172: / Line 174: @@
 ^ voltage2.user_set_smart_bat_0 | 0 | 10 | 2 | 0 | 0 | 0 |
 ^ voltage2.level2_smart_battert_land_0 | 0 | 100 | 10 | 0 | 0 | 0 |
+**Disable DJI's driver license enforcement**
+^ Parameter Name ^ Stock minValue ^ Stock MaxValue ^ Stock defaultValue ^ New MinValue ^ new Maxvalue ^ New defaultValue ^
+^ advanced_function.driver_license_limit_enable_0 | 1 | 1 | 1 | 2 | 2 | 2 |
+^ advanced_function.viechle_license_limit_enable_0 | 1 | 1 | 1 | 2 | 2 | 2 |
 ===== All Parameters Lists =====
   * [[howto:P3C|Phantom 3 Standard - All Parameters]]